Page 10 - Shimadzu UV-3600 Plus

Options Used for Measurements

Electrical, Electronics, and Optics Electrical, Electronics, and Optics

Transmittance Measurement of Rolled Plate Glass for Solar Cell Evaluating Multilayer Dielectric Films
Rolled plate glass is a plate glass with rough surface. When it is scanned by a small integrating sphere, large steps at the Multilayer dielectric films are used to coat lenses, mirrors, filters, and various other optical elements used in
detector switching wavelength may occur, and correct results may not be obtained. When run by an ISR-1503 with an of cameras, binoculars, and other optical devices. The figures below show results from measuring a multilayer
150 mmø, and the sample was turned with 0, 45 and 90 degree, obtained spectra were almost same. And those spectra dielectric film band-pass filter as the incident light angle is varied. By using the UV-3600i Plus in combination with
had very small steps at the detector switching wavelength. an optional MPC-603A multipurpose large sample compartment and variable angle measurement attachment,
In addition to rolled plate glass for solar cell, it is useful for measuring special fibers that cause diffusion. transmittance and absolute reflectance can be measured as the angle of incidence is varied for various light. The
results confirm that, because of the multilayer film structure, varying the incident angle changes which wave-
130.00
lengths are transmitted and reflected.
Shimadzu’s unique aperture design provides condensed light with an excellent signal-to-noise ratio, which
100.00 means it can be converted easily to highly collimated light to accommodate customer measurement requirements.

50.00
Incident angle Incident angle
Red: 5° Black: 0°
Blue: 12° Red: 5°
Green: 30° Blue: 12°
Violet: 45° Green: 30°
-5.00 Violet: 45°
200.0 500.0 1000.0 1500.0 2000.0 2500.0
nm

Electrical, Electronics, and Optics

Absolute Reflectance Measurement of Mirrors
The reflectance of mirrors used in telescopes, lasers, and some other devices is extremely important because it serves as a
factor in determining their performance. The total light reflecting off of a sample can be composed of a specular compo-
nent and a diffuse component. For mirrors, the specular reflectance is the reflectance component of significance. In Options Used for Measurements
addition, reflectance measurements can be made as relative to the reflectance of a background material or as absolute.
Absolute values of specular reflectance are determined by use of an absolute reflectance measurement (ASR) accessory. The ISR-1503 Integrating Sphere ASR-3105/3112/3130/3145 Variable Angle Measurement
figure below shows the results of measuring a mirror. Attachment Absolute Reflectance Attachment Unit for MPC-603A
An absolute reflectance attachment, which enables measuring the reflectance of mirrors, can be installed on the
optional MPC-603A unit. Ref
100％ light M2
Measurement light
M2'
M3 Polarizer position
M1
Integrating
sphere
Sample
Construction
Large Polarizer Set, Polarizer Others
Type I, Type II, Type III ・ Multipurpose Large-Sample Compartment
(MPC-603A)
・ BIS-603 Sample Base Plate Integrating Sphere Sets

10 11