Page 12 - Shimadzu HITS-X Series

Layout Diagram and Site Requirements (HITS-TX, HITS-PX) HITS-X Series

Power Supply: three-phase, 200 V, Note: The main unit of the testing machine must be installed on the first floor of a building,
(IN JAPAN) 14 kVA (HITS-TX), Air inlet on a concrete floor that has a thickness of at least 250 mm (capable of withstanding
16.5 kVA (HITS-PX) the own weight of 1,500 kg). The foundation needs to be constructed by the user.
Cooling water: 50 L/min. (puncture impact testing machine) Avoid installing the machine on an upper or hollow floor, due to the impacts and
Hydraulic vibration generated during high-speed testing.
power supply 640 Power Supply: three-phase 200 V, 6 kVA Although the machine is equipped with vibration-damping springs, care should be
(IN JAPAN) Single-phase 100 V, 1.5 kVA
taken when selecting an installation location where vibrations could be easily
transmitted. Note that the weight of the thermostatic chamber is approximately 800 kg.
830 Optional
Main testing
machine unit Approx. 200 Measurement/Control Unit Caution: Avoid locations with unsuitable conditions such
1200 Heating/cooling unit as those listed below.
(optional)
of corrosive gases
700 700 1) Locations subject to large 7) Locations subject to strong vibrations
fluctuations in temperature
(Recommended: +10 °C to +35 °C) (Recommended: 0.1 G max.)
2) Locations with high humidity, where 8) Locations subject to large voltage
Test chamber (optional) 200 dew condensation may form fluctuations
1020 1000 (Recommended: 20 % to 80 %) (Recommended: Single phase 100 V ±5
1200 2400
Units: mm 3) Locations exposed to the direct air % max., Three-phase 200 V ±10 % max.)
flow from heating/cooling systems Note: Avoid installing devices that can be
4) Locations exposed to direct sunlight negatively impacted by vibrations
5) Locations with large amounts of dust (such as balances) in the vicinity of
6) Locations with significant amounts the testing machine.
Related Products
Electromagnetic Force Fatigue / Endurance Testing System Benchtop Hydraulic Servo Strength Testing Machine Capillary Rheometer Flowtester
EMT Series L-Series Servopulser CFT-EX Series
1kN EHF-LM20kN-10L CFT-EX
5kN ɾ$'5 &9
ɾ$'5 &9

Electromagnetic Micro Testing Machine Electric Motor Driven Actuator
MMT Series Micro-Servo NJ-SERVO Series
MMT-101NV-10 NJ-10kN SERVO

For Research Use Only. Not for use in diagnostic procedures.
This publication may contain references to products that are not available in your country. Please contact us to check the availability of these
products in your country.
Company names, products/service names and logos used in this publication are trademarks and trade names of Shimadzu Corporation, its
subsidiaries or its affiliates, whether or not they are used with trademark symbol “TM” or “®”.
Third-party trademarks and trade names may be used in this publication to refer to either the entities or their products/services, whether or not
they are used with trademark symbol “TM” or “®”.
Shimadzu disclaims any proprietary interest in trademarks and trade names other than its own.
www.shimadzu.com/an/ The contents of this publication are provided to you “as is” without warranty of any kind, and are subject to change without notice. Shimadzu
does not assume any responsibility or liability for any damage, whether direct or indirect, relating to the use of this publication.
© Shimadzu Corporation, 2018
First Edition: November 2017, Printed in Japan 3655-06816-20AIK